ASTM D5863-2000a(2005) 火焰原子吸收分光光度法测定原油和残余燃料中镍、钒、铁和钠含量的标准试验方法

　　

　　When fuels are combusted, metals present in the fuels can form low melting compounds that are corrosive to metal parts. metals present at trace levels in petroleum can deactivate catalysts during processing. These test methods provide a means of quantitatively determining the concentrations of vanadium, nickel, iron, and sodium. Thus, these test methods can be used to aid in determining the quality and value of the crude oil and residual oil.

　　

　　1.1 These test methods cover the determination of nickel, vanadium, iron, and sodium in crude oils and residual fuels by flame atomic absorption spectrometry (AAS). Two different test methods are presented.

　　

　　1.2 Test Method A, Sections -Flame AAS is used to analyze a sample that is decomposed with acid for the determination of total Ni, V, and Fe.

　　

　　1.3 Test Method B, Sections -Flame AAS is used to analyze a sample diluted with an organic solvent for the determination of Ni, V, and Na. This test method uses oil-soluble metals for calibration to determine dissolved metals and does not purport to quantitatively determine nor detect insoluble particulates. Hence, this test method may underestimate the metal content, especially sodium, present as inorganic sodium salts.

　　

　　1.4 The concentration ranges covered by these test methods are determined by the sensitivity of the instruments, the amount of sample taken for analysis, and the dilution volume. A specific statement is given in Note 0.

　　

　　1.5 For each element, each test method has its own unique precision. The user can select the appropriate test method based on the precision required for the specific analysis.

　　

　　1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

　　

　　1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 7.1, 8.2, 8.5, 10 2, 10.4, and 15.1 .